Toolroom and maintenance
Mounted points and abrasive sticks for toolroom finishing
Mounted points, oil stones and abrasive sticks for toolroom repair work, touch-up finishing and maintenance support.
Practical fit
What the grinding job usually demands
Toolrooms need dependable abrasive references for everyday support work, where shape, shank size, grit and safe-speed confirmation matter more than generic naming.
Mounted points, oil stones and abrasive sticks can be reviewed by machine type, shape, size, grit and material.
Confirm the machine type, shank size, RPM, work material and whether the job is bore cleanup, touch-up, hand finishing or internal grinding.
Step 1
Start with machine type, shape, size and shank diameter.
Step 2
Confirm material, removal need and finish expectation.
Step 3
Match grain, grit, grade and bond to the finishing operation.
Step 4
Verify marked safe speed, shank overhang and machine guard before use.
Product references
Catalogue items to start the discussion
Cylinder Type
Mounted Point - Compact Cylinder
Typical body: ⌀3-10 × 6-20 mm
Representative compact cylindrical mounted points for internal grinding and deburring of bores, slots and weld beads on compatible die grinders or flexible-shaft machines.
Round-Nose Cylinder
Mounted Point - Round-Nose Cylinder
Typical body: ⌀3-13 × 10-25 mm
Representative round-nose cylindrical mounted points for contour blending and die or mold finishing without a sharp corner contact.
Bullet Type
Mounted Point - Bullet Profile
Typical body: ⌀10-16 × 16-25 mm
Representative bullet-profile mounted points with rounded ends for blending radii on dies, weld toes and casting fillets.
Small Cylinder (3 mm Shank)
Mounted Point - Fine Cylinder
Typical body: ⌀3-6 × 3-13 mm
Representative fine cylindrical mounted points on compact shanks for restricted-access precision finishing.
RFQ details
Include these details for a stronger quotation
- Mounted-point shape and shank size
- Machine type and RPM
- Work material and finish target
- Required quantity and repeat reference
Buyer confidence
How the specification is kept practical
Abrasive grain, bond and size details confirmed before quotation
Specification review based on material, machine speed and finish target
Body diameter, body length and shank fit discussed against the accepted quotation
Safe-speed details must be confirmed against product label and machine setup
Quote this application
Share the material, machine and quantity.
Sadhvi Udyog can review the abrasive shape, grit, shank size and repeat supply requirement before confirming the suitable quote.