Application fit
Mounted points for die and mold finishing
Mounted abrasive points for die shops, mold makers and toolrooms that need controlled access, profile blending and repeat finishing on cavities, radii, slots and small internal areas.
Buyer problem
What this application usually needs
Die and mold teams usually need abrasive shapes that reach difficult profiles without removing too much material or changing the working geometry.
Cylinder, round-nose, cone, bullet and fine-detail mounted points can be selected by access, radius, body diameter, body length, shank size, abrasive grain and grit requirement.
Mold cavity finishing
Radius and contour blending
Slot and groove cleanup
Edge breaking after machining
Internal bore touch-up
Recommended abrasive references
Products commonly matched to this work
Round-Nose Cylinder
Mounted Point - Round-Nose Cylinder
Typical body: ⌀3-13 × 10-25 mm
Representative round-nose cylindrical mounted points for contour blending and die or mold finishing without a sharp corner contact.
Bullet Type
Mounted Point - Bullet Profile
Typical body: ⌀10-16 × 16-25 mm
Representative bullet-profile mounted points with rounded ends for blending radii on dies, weld toes and casting fillets.
Small Cylinder (3 mm Shank)
Mounted Point - Fine Cylinder
Typical body: ⌀3-6 × 3-13 mm
Representative fine cylindrical mounted points on compact shanks for restricted-access precision finishing.
Cylinder Type
Mounted Point - Compact Cylinder
Typical body: ⌀3-10 × 6-20 mm
Representative compact cylindrical mounted points for internal grinding and deburring of bores, slots and weld beads on compatible die grinders or flexible-shaft machines.
RFQ details
Share these details for a better quotation
- Share cavity access, required profile or sample photo
- Mention tool material and target finish
- Confirm die grinder or flexible-shaft RPM
- Mounted-point profile or product description
- Abrasive grain and grit
- Dimensions and shank size
Quality and repeat supply
Why production buyers can specify with confidence
Abrasive grain, bond and size details confirmed before quotation
Specification review based on material, machine speed and finish target
Body diameter, body length and shank fit discussed against the accepted quotation
Safe-speed details must be confirmed against product label and machine setup
Packing and repeat-order references can be shared where applicable
Ready to quote
Send the application and required quantity.
Sadhvi Udyog can review the shape, grit, machine and quantity before confirming the suitable abrasive specification.